"Arrived on site for dryer making noise,this is a washer dryer combo. Removed panel. Found blower wheels turning independently from motor. Had to break off. Replaced motor and blower wheel. Verified operation. Call complete."

Arrived onsite for dryer not level. On inspection the installer did not adjust the feet to level the unit out. I adjusted the feet so the unit would not rock back and forth. The unit is level now.

"Arrived on site for refrigerator not dispensing ice and making a loud noise, removed back panel. Found noise went away. Adjusted tubing away from cover. Removed and replaced auger motor and shaft. Verified operation. Call complete."

"Arrived onsite for a range with the induction cooktop shutting down after a couple of seconds when any burner is selected. I found multiple stored error codes, F722, F100, F630, F640, F441, F443, F451, & F453. The ovens are working properly so the customer does not have a supply voltage issue. The module needs to be replaced and possibly the induction harness and the oven control. Ordering WB27X30357 CONTROL IND & GASKET, WB18X31599 main harness, WB18X31605 induction harness, WB27X41888 GLASS & TOUCH BOARD & parts authorization.; ordrng 1 WB27X30357 (CONTROL IND & GASKET) and 1 WB18X31599 (Main harness) and 1 WB18X31605 (Induction harness) and 1 WB27X41888 (GLASS & TOUCH BOARD) and 1 Partsauthorization (Parts authorization)"

"Arrived onsite for oven not heating up to select temperature. Tested the sensor it was 1K, tested bake element in it was 19 ohms the broil element was 22 ohms. CX said it all started after a bad storm. Installed new control board and tested unit at 350?. It topped out at 393? and cooled down to 333? before going backup to 380. Unit operating as designed."