Arrived onsite to replace blower. Also found harness needed adjustment. Corrected and tested. Ran auto cycle and then a quick wash. Unit it is now functioning properly. Job complete

"Arrived on site to test unit for not working properly, tested unit found F4E4 error present for faulty blower, cleared conde and attempted to run diagnostics but shortly into the cycle the blower error comes up and unit locks up, will, need to replace, Control and blower on next visit ordering parts office to reschedule no parts installed ; ordrng 1 W11384426 (Blower) and 1 W11439664 (Control)"

"Arrived on site to replace previously diagnosed parts. Upon arrival replaced gear case (W11393685), stator (W11195971), clutch (W10754448), slider (W10734521),rotor (W11260238) and agitator (W11550891). Ran diagnostic cycle, all components are properly engaging and noises have been eliminated. Ran a calibration cycle successfully. Unit is now running as designed, no leaks detected, job complete."

"Arrived on site to test unit for not progressing through a cycle. Upon arrival customer stated unit began to make a noise during the spin, then cycles began to not even start. Will sense but that is the furthest it gets. Hand spun the basket, heard bearings within the gear case grinding. Inspected under the unit and found rust and oil throughout. All the oil has leaked out and tub seal has been broken causing a leak on all bottom end components. Rotor could not be removed. Will need a full rebuild. Gearcase, slider, clutch, stator and rotor must be replaced. Ordering additional parts required, no parts installed, rescheduled for 04/08.; ordrng 1 W11195971 (Stator) and 1 W11260238 (Rotor) and 6 W11027980 (Stator screws)s and 1 W11550891 (Agitator)"

"Arrived on site and replaced slider(w10734521), control(w11627517)suspension(w11400156), rotor guard(W11627512), rotor(W11260238) and screws(W10846509). Unit is now working as designed. No leaks detected. Job complete."