"Arrived on site for unit shaking violently while spinning. Upon arrival, found suspension to be faulty. Ran diagnostics and all other components check good. Proceeded to replace W11130362 suspension. Tested unit and now unit is functioning as designed. No water leaks detected at this time"

"Arrived on site to inspect washer not getting enough water. Upon further inspection, I placed the unit in diagnostics showing error codes F0E3-overload, F0E4-spin limited by water temp, and F3E2-inoet water temp fault. I cleared the codes and continued with testing and found the unit is not getting enough water during diagnostics. Once testing was completed, I gained access to the valve and found the cold valve screens with debris inisde. I removed and replaced the valve assembly and calibrated the unit. Retested in diagnostics and the unit is operating as designed. No water leaks observed during service, job completed. W11165546"

Arrived on site to install previously ordered part. Replaced manifold W11613489. Unit is operating as designed. No leaks are present. Job complete

Arrived onsite for newly installed compressor not running. Found internal lights and fans run and condenser fan runs. Called techline for assistance as original compressor was not running and now the new one wasn't. Spoke to Kirt. SR#7740686931. Ohmed compressor and was not shorted. Ran voltage checks and found no voltage from Orion board to power compressor. Replaced Orion with compressor and tested. Unit is now functioning properly. Advised customer to monitor for 48hrs. Job complete

"Arrived onsite for unit needing sealed system repair. Found corroded condenser lines. Will need to order condenser, non Uv drier and Oilless guages to complete repair. Unit is in tight space . Recommend 3 hr time frame. Office to reschedule ; ordrng 1 W11548259 (Condenser) and 1 Oillessguages (Oilless guages) and 1 W10843121 (Non UV drier) and 1 3hr (3hr)"