Arrived onsite for washer leaking. On inspection the customer doesnt have a water heater in the outdoor wash room. The water is coming out of the hot inlet valve even with cold only selected. Customer had a plug that I installed on the hot water hose to stop the water form coming out when the washer is in use. No more water leaks detected during inspection.

Arrived onsite for a washer that will not draining. Upon inspection I found that the drain pump harness had came separated. I repaired the harness and tested the unit serval times and found unit operating as designed job complete.

"Arrived on site for dryer making loud noise. On inspection I turn the tub by hand and it had a roared loud. Then put in diagnostics and it got real loud. Gain access to,the bottom of them unit and there was no oil signs. Took the pulley still could not find any evidence of oil leak. I took the wash plate to see it there was any thing causing the noise. I again spun the unit by hand it sound like the bearing were bad. I replaced the gearcase and ran the unit in diagnostics mode and the roaring noise was gone.

Arrived onsite to install previously diagnosed parts. On inspection found the door harness had a short. Installed new door on refrigerator and tested. The water and ice are now working. Found the short was on the paddle harness. The black was cut and bare. The unit is operating as designed and no water leaks detected.

Arrived on site for refrigerator not dispensing ice and water. Tested the door switch at the voltage UI board at j4-4 and j4-16 120vac when door closed and 0 volts when door open. The UI has 120vac supplied to the board. Working with Susie we came to the conclusion that the harness in the door has short in it not allowing for water or ice to be called for when the lever is pushed. No water leaks detected during service ; O-emld tckt