Arrived on site for wall oven no heating properly. Upon arrival confirmed issue and found both oven sensors ohming out of range at room temp. Replaced upper oven sensor and retested unit. Found upper oven averaging 348 after 20 minutes when set to 350. Rescheduled customer to complete repairs W10859573 lower oven sensor.; ordrng 1 W10859573 (Sensor (lower oven)) and 1 W10859573 (Sensor)

Arrived on site for microwave needing previously diagnosed ACU. Upon arrival reconfirmed issue and installed required ACU. Upon reassembling unit I found all functions fully restored to microwave and unit heats as designed. Call complete

Arrived on site for microwave that sparked then wouldnt turn of surface bulb after sparking occurred. Upon arrival confirmed issue and found an electrical burning smell coming from control. After further inspection I found control relay had cracked and fused together and sending constant voltage to bulb keeping it on. Called whirlpool safety team and spoke with Kesha (sr# 7735594513) reported unit would need new ACU control. Found unit still heats as designed with no other failures found on site. ordrng 1 W11552021 (Control)

"Arrived on site to diagnose dryer that was not heating. Ran unit and found it powers on and spins, but generates no heat. Checked safety devices and found all good, heating element good. Checked incoming voltage and found L1 only has 40v present, and missing voltage. Advised customer needs to contact an electrician to come out and resolve the dropped voltage. Call complete."

Arrived on site for range showing bad line error. Upon arrival confirmed issue and error on display. After further testing found no wiring failures or control issue in unit. Found error caused from how home is wired up to electrical system/secondary power generator that had switched off power temporarily. Instructed customer to keep eye on power supply and found u it could fully function as designed with no failures.