Arrived onsite and found evidence of leaking from the ice bin due to insufficient temp in freezer. Determined cause to be ice blockage on evap Defrosted unit and verified fans and defrost heater and timer are working. Advised customer to observe for normal operation and report back if there is ongoing hi temps in the freezer. All else checks good. Spoke with owner Marc.

Arrived on site for unit not finishing cycles . Turning drum bye hand. Ran diagnostics found rear bearing going out .

"Arrived on site ,replaced mag. Ran test heat . Unit is heating to Whirlpool specs

"Arrived on site and inspected range and found saved error code for upper blower fan. Ran diagnostic cycle to confirm blower fan is getting voltage. After replacement confirmed operation by beginning a pre-heat cycle and observing until fan came on and did not generate a new error code, job complete.

"Arrived onsite for non cooling sealed system repair. Recovered refrigerant and removed faulty compressor. Replaced compressor and access valve. Checked for leaks with nitrogen. While checking for leaks found dark oil dripping from cap tube at dryer. Called tech line. Took pic. SR#7736513868. Tech designated as internal burnout. Whirlpool will contact customer in 3-5 business days. Job complete"