"Arrived on site to test unit for not working properly, tested unit found water leaking from under the unit, inspected and found tub seal leaking causing excessive rust, unit is not powering on do to wet components shorting out control, customer stated that if they dont run it for a while the they are able to power it on, will need to replace control board W10581552, gear case W11454372, motor W10832724, cam W10721967, belt WPW10006384, actuator WPW10006355, shield WPW10550173, shield screws W11573574x2, wash plate WPW10215115, suspension W10780044, and potentially Basket W10521298, office to get authorization and reschedule ; O-emld tckt"

"Arrived on site to test unit for shutting off, customer stated that unit has no issues running on timed dry, but sometimes sensor dry dont work properly, explained to customer how it works and advised customer to use timed dry if load is small or mixed fabrics, put damp clothes over moisture sensors and ran unit for 15 minutes, time slowly decreased and when cloth became dryer then the times started adjusting according to moisture content inside cloth, unit is running per manufacture specifications job complete no parts installed"

"Arrived on site to install previously diagnosed pressure regulator and water line, installed and tested, noise is no longer present, unit is running as designed no leaks detected job complete installed 8212547RP, W10786952"

"Arrived on site to test unit for frost in freezer, tested unit found top of FC gasket not sealing properly, used heat gun to mold gasket, all gaskets are now sealing properly no leaks detected job complete, no parts installed"

"Arrived on site to test unit for leaking water, tested unit found leak forming front left corner, inspected softener dispenser and found multiple retaining clips broken and are responsible for leak, ordered top trim piece and softener dispenser office to get authorization and reschedule ; ordrng 1 W11550898 (Faucet bezel) and 1 W11569112 (Softener dispenser), states that autho needed"