"Arrived on site for a washing machine. That is not completing cycles. Inspected unit and work area. The customer advised the unit will wash but will not spit out the clothes. I ran the unit through diagnostics and found an F8 E1 (low/no water detected during the fill) error code. Around the unit through diagnostics and tested both valves. I found the cold water valve, barely trickling any water in. The customer stated that a few weeks ago, they had trash come through the line and they cleared it out and it seem to work. However, it stopped working about a week ago. I went ahead and replace the valve assembly and tested the unit. The unit began to work and operate as designed. Call complete. W11210463"

Arrived on site for microwave making a loud noise when turned on. Upon arrival confirmed issue and traced it to improper install of vent assembly over unit causing rattling vibration. Installed W11113654 pad and adjusted vent. Found noise removed. Call complete

Arrived on site or range not igniting oven properly. Upon arrival confirmed issue. Found air-gas intake not closed half way for propane and and regulator valve not fully set to propane. Made adjustments to valve and intake and found oven working as designed. Call complete

Arrived on site for refrigerator not cooling. Upon arrival found large defrost issue in fc evap area. Found thermistors working but defrost harness and ui werent working in sync. Replaced hv and ui controls and harness after removing all ice. Informed customer to give unit 24 hrs to stabilize temps. Call complete

"Arrived on site for refrigerator not making ice, upon arrival found harvest teeth getting stuck I. Rotation against stationary slope. Replaced ice maker and tested unit. Found it filling as designed and teeth not getting stuck in rotation. Informed customer to give unit 24 hrs to stabilize temps. Call complete"