"Arrived on site to diagnose compactor that would not stop running the ram when it hit top position. Examined unit and found the start pedal was bent outwards, and the spring was missing. Was able to bend back the start pedal and spring and tested. Verified unit working as designed. No parts needed."

"Arrived on site for refrigerator needing shelving and paint. Upon arrival used w756744 paint, and w11350962 shelves. Found unit working as designed. Call complete"

"Arrived on site for ice machine needing harness and control. Upon arrival reconfirmed issue and installed w11034363 control, and harness w11126268. Tested unit and found it working as designed. Call complete"

"KRMF706EBS01 Arrived to inspect no cool. I found the source of the leak at the dye drier connection and I removed and replaced the drier to correct. The customer advised the last repair did not last overnight. I vacuumed the system to 270 microns and then it held below 500, reaching 470 microns after approximately 15 minutes and steadily tapering off, towards the end of the monitored time. The increase in microns is likely due to the fact the system had a severe leak and lost refrigerant while running, creating a vacuum in the low side and when shut down, it drew significant moisture. The customer will contact us if issues persist. No water connections to unit."

Arrived on site and installed replacement lint screen. Unit working and heating correctly. Repair completed. Parts used - WPW10516085.