Need Appliance Repair Service? Have a general question?
We love solving problems! Let us know how we can help by reaching out below.
for Sunset Valley, TX
Great Service as usual!
Margaret - Sunset Valley, TX
Luis was on time and had our refrigerator running in about 20 minutes. Very professional.
OVEN KITCHENAID KOSE500ESS02 Arrived on site to test unit for unit not heating to temp. Test unit and found unit temp off set unit to 350 and unit only getting to 308. Replaced sensor test unit by heating to 350 and unit getting to 354 job complete. Showed customer how to do a calibration if needed.
WASHER WHIRLPOOL WFW96HEAU0 "arrived on site and found saved error codes F8e1, f5e2, washer is stacked. There are two sets next to each other. Took pictures of installation any repairs would require two technicians. Found debris on door where it contacts bellow and it is dripping past bellow seal. Bellow is not cracked or broken, after cleaning it ran another cycle and it is no longer leaking. No water leaks detected at time of service, job complete."
REFRIGERATOR WHIRLPOOL KRFF507ESS01 "Arrived on site for unit shutting off,unit shutting on and off diagnosed faulty main control. Installed new main control powered unit on compressor and fans running unit working as designed."
OVEN WHIRLPOOL KOSE500ESS02 "Arrived on site replaced temperature sensor after replacement confirm oven is now heating properly. Show customer calibration options available on oven, no for the repair is required at this time, job complete"
MICROWAVE WHIRLPOOL KMCS3022GSS0 Arrived on site and found microwave door does not open every time button is pressed. Microwave is a replacement only product no parts are available. Recommended that it be turned in to kitchenaid for replacement. Job complete
KRFF507ESS01 Arrived on job for complaints of slow ice production and soft cubes. Found ice door not closing tightly. Will need door and separator.
Arrived on site for washer not working and giving a f1 error code, found bad ccu board, I replaced board and ran trough recalibration and test cycle, unit tested good. Water lines were dry at time of service.