Need Appliance Repair Service? Have a general question?
We love solving problems! Let us know how we can help by reaching out below.

How can we help? Do you need appliance repair?

Local Reviews
for Granger, TX

Appliance Express Rated 5.0 out of 5 stars based on 3 customer reviews

Map of Granger, TX

Great service




Review of Appliance Express

The technician was very friendly and polite. He was knowledgeable and easily took care of the problem. I was very satisfied with his work.


Map of Granger, TX

Great Service, Very knowledgeable of his job




Review of Appliance Express


Map of Granger, TX

great service!!




Review of Appliance Express

Cost not applicable because fridge still in manufacture warranty. Andy was very well mannered, did an excellent job.


Arthur B.

Arthur B.

WASHER WHIRLPOOL WTW4816FW2 Arrived onsite for customer complaint of top load washer not starting. Attempting to run diagnostics and found control not responding. Found control DOA. Removed and replaced control assembly. Reassembled and calibrated unit. Unit completed successfully. No other issues found. All water connections were dry at time of service.

Near S Guadalupe St, Granger, TX 76530
Andy  B.

Andy B.

DISHWASHER WHIRLPOOL WDF530PAYM3 "Arrived on site for dishwasher leaking. Tested and inspected unit and found unit leaking from vent. Removed failed parts and replaced with new. Tested unit and all operations are normal. No water leaks present at time of service.

Near Co Rd 320, Granger, TX 76530
Andy  B.

Andy B.

WASHER MAYTAG MVWX700XW1

Near E Ash, Granger, TX 76530
Andy  B.

Andy B.

REFRIGERATOR WHIRLPOOL WRF535SMBM00 Arrived on site to install previously diagnosed parts. Removed failed parts and replaced with new. All operations are normal. No water leaks present at time of service.

Near Granger, TX 76530
Andy  B.

Andy B.

REFRIGERATOR WHIRLPOOL WRT318FZDW05 Arrived on site for refrigerator not cooling. Called tech line and spoke with Scott (SR# 7724772733) Made aware of issues. Went through diagnostics. Was informed that it was in the heat element or wiring going to element/fuse. Found wire with fuse disconnected from unit. Reinstalled wire and put into defrost. Element got hot and started to defrost. Steamed out remaining ice buildup and reassembled unit. All operations are normal. No water leaks present at time of service.

Near S Rio Grande St, Granger, TX 76530
Andy  B.

Andy B.

REFRIGERATOR WHIRLPOOL WRF535SMBM00 Arrived on site for refrigerator freezing food. Tested refrigerator temperatures in different locations and found to range between 43° and 46° tested in freezer and found at 19° noticed temperature settings were not at recommend settings. Called tech line and spoke with Kevin Was instructed to set settings at recommend levels. Ordering gaskets and will return with pre-diagnosed parts in case any issues on return trip. No water leaks present at time of service.; ordrng 2 W10830162 (GASKET )s

Near Granger, TX 76530
Joel G.

Joel G.

REFRIGERATOR WHIRLPOOL MRT118FFFE00 "Arrived on site to install parts ordered by previous tech. Found system low on charge and poor frost pattern. Compressor has good suction and discharge so it’s fine. Replaced evap, drier and access valve. . Verified operation and verified no water leaks at time of svc call."

Near E Fox, Granger, TX 76530
Andy  B.

Andy B.

REFRIGERATOR KITCHENAID KRMF706ESS00 "Arrived on site for refrigerator lights not operating. Tested and inspected unit and found failed pantry control, door and wire harness for control. (See SD-QuickPic)

Near Granger, TX 76530
Andy  B.

Andy B.

REFRIGERATOR MAYTAG MRT118FFFE00 Arrived on site for refrigerator not keeping temperature in freezer and freezing food in refrigerator. Tested and inspected unit and found temperature issues in freezer and refrigerator. Found ice ball on upper right side of evaporator and very little frost pattern elsewhere. Called tech line and spoke with Ed and was informed it is likely a sealed system issue. Spoke with CS and was instructed to order compressor and evaporator. Office to schedule return trip. No water leaks present at time of service.; ordrng 1 SEENOTE (OFFICE TO SCHEDULE ) and 1 TJ90SF8404 (ACCESS VALVE ) and 1 W10507884 (COMPRESSOR ) and 1 W10836706 (EVAPORATOR ) and 1 W10843121 (DRIER )

Near E Fox, Granger, TX 76530
Andy  B.

Andy B.

REFRIGERATOR WHIRLPOOL WRT318FZDW05 Arrived on site for refrigerator not cooling. Tested and inspected unit and found unit not going into defrost. Found failed control and thermistors. Defrosted unit. Removed failed parts and replaced with new. Tested and all operations are normal. No water leaks present at time of service.

Near S Rio Grande St, Granger, TX 76530
Jonathan  S.

Jonathan S.

WASHER MAYTAG MVWX700XW1 "Arrived on site for washer not agitating or spinning. Per diagnostics mode and checked fault codes. Found faulty code F0-E2 over suds and F7-E1 speed sensor fault. Checked basket to see if it would spin freely. Gained access to control and measured speed sensor at 2.5 k ohms. Gained access to actuator and found mechanically failed/ spring clip broken. Removed failed actuator and installed new. Performed calibration test. Ran manual test mode. All tested good, no water leaks present.

Near E Ash, Granger, TX 76530
Jerry C.

Jerry C.

DRYER MAYTAG MEDC215EW1 "MEDC215EW1 Arrived to inspect paint issue. I found the paint was incorrectly applied and easily coming off at the ear of the drum. I removed and replaced it and tested. Operational test good, no lint within newer chassis."

Near S Granger, Granger, TX 76530
Jerry C.

Jerry C.

WASHER MAYTAG MAV6451AWW "MAV6451AWW Arrived to inspect no operation. I found the lid switch cam had failed. I depressed the switch manually and all functions were present. Office to order the plunger, guide tube and cam. No leaks observed during service. ; ordrng 1 W10814230 (cam) and 1 WP22002754 (plunger) and 1 WP22002757 (guide tube)"

Near Roswell St, Granger, TX 76530
Jerry C.

Jerry C.

WASHER MAYTAG MAV6451AWW The customer requested a reschedule and the office to contact them to schedule. No access to unit.; saved tckt

Near Roswell St, Granger, TX 76530
Steve C.

Steve C.

REFRIGERATOR WHIRLPOOL MRT118FFFE00 Arrived on site for the unit is not making ice. Customer advise she has a extended warranty through AIG. Called MS and advise we cannot service the unit until we receive a dispatch. Found the freezer is at 20°.

Near E Fox, Granger, TX 76530
Wesley P.

Wesley P.

REFRIGERATOR WHIRLPOOL MRT118FFFE00 Arrived on site and found unit operating as designed. Was able t cycle ice-maker and found operating properly. Charged 108.24 and stated that if unit icemaker causes problems in future to call back.

Near E Fox, Granger, TX 76530
James C.

James C.

Arrived on site and tested unit. Found that console has discolored and touch panel blistered. Inspected upper oven vent and found to be routed and secured properly. Installed new console and tested. Unit working properly. Job complete

Near E Elm St, Granger, TX 76530
James C.

James C.

Arrived on site and tested unit. Found motor humms but will not run. Removed rear cover to access blower housing and found a snak had worked its way into the blower. Unit not repairable due to odor that would come from the dryer heating up during operation. Customer decided not to go forth with repair. Job complete

Near E Elm St, Granger, TX 76530
Dona W.

Dona W.

Arrived on site for no ice production, found from delivery water was not turned on. Turned water on, verified no leaks or drips on line. Unit called for water and started ice production. Freezer door did not come with whirlpool name plate. MS approved D2C to address to send nameplate. Customer will install nameplate. Unit is cooling properly. All operations check good. All water connections dry.

Near W Elm St, Granger, TX 76530
Nathaniel B.

Nathaniel B.

Model MMV1174FB0, Arrived on call for unit not heating, found transformer arced prior replaced cap, mag, diode and transformer and tested and all checks good, tested more than 3 times at customers request ,call complete.

Near FM971, Granger, TX 76530
Nathaniel B.

Nathaniel B.

Model MMV1174FB0, Arrived on call for unit not heating, found transformer arced prior replaced cap, mag, diode and transformer and tested and all checks good, tested more than 3 times at customers request ,call complete.

Near FM971, Granger, TX 76530
Mike C.

Mike C.

Maytag Dryer MED6600TQ0 Arrived to find unit not starting a cycle and getting a F1 error code. Found control bad on unit. Installed new control and checked operation, checked good. Cleaned any lint from unit. Control $159.99 - DR300 $59.99 - Price confirmed with MS

Near Co Rd 363, Granger, TX 76530