Need Appliance Repair Service? Have a general question?
We love solving problems! Let us know how we can help by reaching out below.
for Buchanan Dam, TX
Thanks!!! Works perfect again.
James - Buchanan Dam, TX
Terry - Buchanan Dam, TX
Was so glad to have such professional service from Clif on my GE appliance. Very courteous. Repaired my appliance on the first trip. Could not be happier.
polite and professional
Linda - Buchanan Dam, TX
J. arrived on time, corrected the problem on my dryer in short time
Cliff came back to reconnect a wire he forgot to conect on his original repair trip. He was prompt and courteous.
Ed - Buchanan Dam, TX
Ed - Buchanan Dam, TX
Cliff did a great job. The only problem is that he will need to return to reconnect the sensors. The dryer now shuts itself off after 5 minutes.
OVEN WHIRLPOOL WFE320M0EW2 Arrived on site and found clock display off and chassis energized. Customer turned breaker off and I was able access harness to test for short. I found no shorts in harness and inspected outlet. I found L1 has no voltage and L2 to ground has 240v. Instructed customer that and electrician will need to repair outlet. Job complete
MICROWAVE KITCHENAID KMHC319EBS2 "arrived on site to install previously diagnosed and ordered part. Per technician CL’s diagnosis, I removed and replaced the main control board due to failure and tested. Unit operated as designed. Job completed."
MICROWAVE KITCHENAID KMHC319EBS2 Arrived on site to diagnose a microwave that will not complete conVection preheat. Tested unit per tech sheet and found failed control board. ; ordrng 1 W11218381 (CONTROL)
DRYER MAYTAG MEDC300BW0 "Arrived on site for dryer not powering on. Performed diagnostics and tested voltage to unit, found within range. Gained access to fuses and heating element. Tested operation, tested good. Was unable find customer on my way out to inform them that dryer is fixed."
RANGE UNKNOWN ZDP366NPSS Arrived on site to diagnose a range that is throwing error codes when oven is used. Found airflow switch actuator bent from factory causing blower in unit not to activate airflow switch. Reset switch actuator to the proper position and tested unit. Found all is functioning properly at this time.