Need Appliance Repair Service? Have a general question?
We love solving problems! Let us know how we can help by reaching out below.

Local Reviews
for Bellmead, TX

Appliance Express Rated 5.0 out of 5 stars based on 1 customer reviews

Map of Bellmead, TX

Honest & Reliable.




Review of Appliance Express

Appointments are made and kept. Quality work in a timely manner. Overall satisfactory service.


Jonathan M.

Jonathan M.

WASHER MAYTAG MVWB855DC4 Arrived on site for a washer that the customer had questions about the fill levels. Inspected unit and work area. Customer advised that when she’s trying to fill the unit with cold water that it barely dribbles. Confirmed customers complaint and found the control sending proper voltage to the valve but the valve solenoid not opening fully. Replaced valve and tested unit. Unit is now working as designed. Call complete.

Near Bellmead, TX 76705
Jonathan M.

Jonathan M.

WASHER WHIRLPOOL WTW5105HW0 "Arrived on site for a washer that’s making a squeaking noise at the beginning of the cycle. Inspected unit and work area. Tested unit and a normal wash operation and confirmed customers complaint. Tested the unit without a belt on and unit did not replicate the sound. Ordering gear case, motor, and splash assembly for repair. Ordering parts in office will need to schedule a return visit due to out of stock parts.; ordrng 1 W10721967 (drive pulley) and 1 W11026785 (motor-drve) and 1 W11423758 (GEARCASE)"

Near N League, Bellmead, TX 76705
Jonathan M.

Jonathan M.

REFRIGERATOR WHIRLPOOL WRS325SDHB05 Arrived on site for refrigerator that’s not cooling in the refrigerator or freezer sections. Inspected unit and work area. Found frost inside the freezer section over the evaporator. Placed unit in service diagnostics and found the defrost sensor open. Went to steam off frost and found the sensor is showing closed again and heater kicked on. Went ahead and replaced wire harness and tested unit. Unit is working as designed. Call complete.

Near N League, Bellmead, TX 76705
Jonathan M.

Jonathan M.

WASHER MAYTAG MVWB765FW4 Arrived on site for a unit that is grinding. Inspected unit and work area. Customer advised that she’s just hearing certain sounds that she’s never heard before and just wanted to make sure the unit is working properly. Lift it up unit and found rotor screw not completely tight and loose. Did not find any damage done to the rotor or stator. Tightened the screw and tested unit. Ran unit through an auto test and found unit working as designed did find change in between her agitator causing a somewhat grinding sound. Ran unit through a high speed spin and could not replicate issue. Advise customer to throw in Clothes for a wash cycle. Customer ran through a load of bedding. Ran unit through the wash cycle and customer advised that she heard the sound during the agitation. Found coins in between the agitator and basket. Removed coins and tested unit. Unit ran as designed. Ran unit through drain and spin and unit is working as designed. Advise customer that her loo

Near Michigan St, Bellmead, TX 76705
Jonathan M.

Jonathan M.

WASHER MAYTAG MVWB765FW4 "Arrived on site for a washing machine that still making a rattling sound during agitation. Inspected unit and work area. Placed unit into service diagnostics and found no stored area codes. Placed unit into a manual agitation and could not replicate the sound. Added water to the unit and put clothes in the basket trying to emulate a cycle. Unit ran as designed and could not replicate issue. The customer stated that this issue has been extremely intermittent and that the more clothes she adds, the less likely she is to hear the sound. She indicated that the gear case had been replaced recently and that she was questioning whether that was a defective part. I advised her that that was probably not her issue but that I would contact whirlpool experts to see if there was anything else they could think of. I called Techline and spoke to Leon SR# 7728552174. He advised to check the rotor and stator for wear and that if We could not find anything that there’s nothing

Near Michigan St, Bellmead, TX 76705
Jonathan M.

Jonathan M.

WASHER MAYTAG MVWB765FW4 Arrived on site for washer that’s making a stripping sound as it agitates. Inspected unit and work area. Removed agitator and found agitator spline stripped. Replaced agitator and tested unit. Unit is working as designed. Call complete.

Near Michigan St, Bellmead, TX 76705
Tyler  G.

Tyler G.

WASHER MAYTAG MVWB765FW4 "Arrived on site for washer that was making a squealing noise. After further inspection and running diagnostics I could not find any error codes but when put into a manual test the washer made some grinding and squealing noises during the agitation and spin cycle at that point I found out that the gear case, clutch, and slider were all bad. I replaced all three parts and retest of the unit and everything is working at 100% and as designed. Call complete."

Near Michigan St, Bellmead, TX 76705
Tyler  G.

Tyler G.

WASHER MAYTAG MVWB765FW4 "Arrived on site for washer that was making a squealing noise. After further inspection and running diagnostics I could not find any error codes but when put into a manual test the washer made some grinding and squealing noises during the agitation and spin cycle at that point I found out that the gear case, clutch, and slider were all bad. I replaced all three parts and retest of the unit and everything is working at 100% and as designed. Call complete."

Near Michigan St, Bellmead, TX 76705
Jonathan M.

Jonathan M.

REFRIGERATOR WHIRLPOOL WRX735SDHZ01 Survived on site to install previously diagnosed part. Replaced all pieces of the left-hand door and replaced onto new door. Tested unit and unit worked as designed. Call complete.

Near Bellmead, TX 76705
Arthur B.

Arthur B.

DRYER WHIRLPOOL WED6620HW1 "Arrived onsite for customer complaint of dryer not coming on. Found when arrived, found unit was stacked. Removed console and found harness between control and console not fully seated. Secured harness and tested unit. Dryer works as designed. No other issues found. Dryer vent and lint trap was clean of lint was clean at time of service."

Near Fannin St, Bellmead, TX 76705
Dylan  T.

Dylan T.

DRYER MAYTAG MEDC465HW0 Arrived onsite complaint was unit not heating took back off found it was losing power going yo the heating element from the timer replaced the part ran unit all tested good

Near Parrish St, Bellmead, TX 76705
Al R.

Al R.

REFRIGERATOR WHIRLPOOL WRX735SDHZ01 "Arrived to inspect French door refrigerator not dispensing crushed ice.Customer advised the ice clumps up in the chute after dispensing, but didn’t realize the option on the UI to change ice type.Unit dispenses ice as designed.Customer instruct.All water lines were dry at the time of service.CUSTOMER SATISFIED JOB COMPLETE."

Near Bellmead, TX 76705
Arthur B.

Arthur B.

HTDX100EMWW (Dryer) - Arrived onsite for customer complaint of dryer knob broke off and can’t start unit. Found knob broken. P&L are as follows; WE1M652 (Knob) $20.86,DR100 $99.99 plus taxes. Installed new replacement knob. Tested unit. Unit heat and tumbles as intended. Dryer vent and lint trap was clean of lint at time of service.

Near Bellmead, TX 76705
Mike G.

Mike G.

WFW75HEFW0, Arrived on site for unit Shaking violently.checked unit and found that the shipping bolts were not removed, removed shipping bolts and checked unit and unit checked fine at this time... no water leaks at time of srv....

Near N Interstate 35 Frontage Rd, Bellmead, TX 76705
Mike G.

Mike G.

WFW75HEFW0, Arrived on site for unit Shaking violently.checked unit and found that the shipping bolts were not removed, removed shipping bolts and checked unit and unit checked fine at this time... no water leaks at time of srv....

Near N Interstate 35 Frontage Rd, Bellmead, TX 76705
Mike G.

Mike G.

NTW4516FW1, Arrived on site to install new actuator checked unit after repair and is is filling, washing, draining and spining checked unit for water leaks and no leaks found at time of srv..... Unit checked fine at this time.....

Near S Interstate Hwy 35, Bellmead, TX 76705
Mike G.

Mike G.

NTW4516FW1, Arrived on site to install new actuator checked unit after repair and is is filling, washing, draining and spining checked unit for water leaks and no leaks found at time of srv..... Unit checked fine at this time.....

Near S Interstate Hwy 35, Bellmead, TX 76705