"Arrived on site to inspect washer error codes. Upon further inspection, I placed the unit in diagnostics showing error code F9E1-drain error. Cleared the code and manually tested the dr pump,and it failed to come on. I unplugged the unit and tilted it back and found the harness to the drain pump was broken. Due to the possibility of the main control being shorted, I was granted authorization to replace the main control, drain pump and lower harness. I removed and replaced the main control and harness and tested the drain pump. Unit began to drain as designed. I calibrated the unit and retested in diagnostics and unit is operating as designed. The drain pump was not needed at this time. No water leaks observed during service, job completed."

Arrived onsite for cooktop bezel not square. On inspection the installer had pushed down on the bezel to make it flush with the counter. I installed the new bezel and name plate. I adjusted the dual burner to fix the igniting issue. The unit is operating as designed and no gas leaks detected during service.

Arrived onsite for dryer will turn on. On inspection I found no voltage at the termite block. Went to the breaker box and found the breaker tripped. Flipped it back on and tested unit. The unit is operating as designed.

"Arrived onsite for dryer making a noise. Ran the unit and could a pumping noise. Gain access to the drum and found the blower wheel was free spinning and hitting the blower housing. I had break off the blower wheel, I installed a new motor and blower wheel. Tested unit and the dryer is operating as designed."

"MDB4949SKZ0 Arrived to inspect leak. I found the drain line that is located within the sump area had split just below the connector at the distributor. Office to order part, unit has water to it shut off and no leaks of the water supply observed during service. ; ordrng 1 W11551233 (Hose-Drain, Sump)"