Arrived on site to test unit for unit giving f8E4. Found water in float pan. Removed water test unit and unit test good T this time job complete.

"Arrived on site to test unit for screeching noise, tested unit found a a screw holding the shield fell out and got stuck between cam pulley and cover, when customer would run larger loads it would grind on the cam damaging it, replaced cam, secured cover with larger diameter screws, tested unit unit is now running as designed, no leaks detected job complete"

"Arrived on site to test unit for unit extremely out of balance, tested unit found suspensions extremely bouncy, replaced and tested, unit is now running as designed, advised customer not to over load unit due to to cause of suspension failure, no leaks detected job complete"

"Arrived on site to test unit for spinning after cycle, tested unit found control sending voltage to motor when not in program, replaced control and capacitor as precautionary, unit is now operating as designed, no leaks detected job complete"

"Arrived on site and found capacitor has failed and is leaking, took picture. After replacing capacitor ran a calibration cycle and washer is operating normally, job complete."