Arrived on site to test unit for moisture retention after wash cycle complete. Found no error codes. Ent opening and closing as designed. Element is good and engaging properly. Advised customer to prop door open when cycle is complete to allow steam to escape. No leaks detected. Job complete.

"Arrived on site to test unit for no heating. Tested unit found hi limit t-stat reading open. Replaced t-stat and tested, unit is now heating. Advised customer to clean vent once a year to prevent restrictions in the airflow system. Unit is running as designed, job complete."

"Arrived on site to test unit for no ice production. Tested unit found ice maker not installed correctly and missing screws. Also fill tube was pushed back into unit causing water to splash on top shelf and freeze. Installed ice maker properly and fitted the fill tube to its proper position. Tested unit, ice maker components are engaging properly and filling with water. Unit is now running as designed, no leaks detected, job complete."

"Arrived on site to test unit for not freezing. Tested unit, found compressor not engaging and not pulling amperage. Replaced start device and run capacitor from truck stock, compressor is now engaging and unit is developing an ideal frost pattern. Unit is now running as designed, job complete."

"Arrived on site to test unit for not draining, tested unit and found drain plug not knocked out by installers. Knocked out drain plug and tested unit, unit is now draining and running as designed, job complete."