Arrived on site to test unit for frost forming. Found evap completely frosted over. Was able to engage defrost element in diagnostics. Recommend replacing evap thermistor and control. Ordering UI to ensure completion on return visit. Office to reschedule. ; ordrng 1 W11558182 (Control) and 1 WPW10384183 (Thermistor) and 1 W11518204 (UI)

"Arrived on site to h site to inspect unit for squealing noise during spin cycle. Upon closer inspection found unit unbalanced, balanced unit so basket would be evenly spaced between 4 walls. Inspected gearcase and rotor saw no signs of excessive wear. Ran diagnostic cycle while unit was spinning and washing could hear a hum or buzz coming from the lower portion and appeared to be struggling to begin spinning. Replaced clutch and stator unit didnt seem to lag after replacing but found basket jumping excessively during both diagnostic cycles, found holes not punched through basket. Ordering basket and will return. Office to reschedule. ; ordrng 1 W11178227 (Tub)"

Arrived on site to test unit for F1E0 error. Found bad control board replaced board test unit and unit test good job complete

"Arrived on site for cooling complaint. Removed evaporator cover,found ice ball on inlet of evaporator and partial to no frost pattern. Replaced the evaporator,drier and the compressor again,vacuumed system down unit kept vacuum recharged system to 56g of R600a powered unit on checked low side pressure good,checked frost pattern good"

"Arrived on site to test unit for leak. Put unit in diagnostics and inspected under the DW. Found leak coming from wash motor. Replaced wash motor assembly and tested, all components are properly engaging. Unit is running as designed, no leaks detected, job complete."